How to maintain the roll forming machine

First of all, the surface of the roll forming machine must be cleaned. The punching process of the upper die of the machine: the input shaft is driven by the motor through the pulley, the upper shaft is driven by the pinion and the big gear, and the sliding seat equipped with the upper die is driven by a set of cam mechanism Move up and down to achieve compression tiles.

The indexing position of the worktable is achieved by the gear set installed at the end of the upper shaft, driving the shift pin gear, and rotating the sheave wheel installed on the hexagonal shaft to achieve indexing and positioning. Each end of the upper shaft is equipped with a return cam, which is installed on the same shaft and is conjugate to the compression cam. The positioning rod and the positioning plate are used to realize the precise positioning of the lower mold in the working position. The lubrication pump is installed on the left and right sides of the chassis On both sides. When the machine is working, the oil pipe transports the lubricating oil to the frictional moving parts. Personnel who understand the structure, performance and operating procedures of the machine must not start the roll forming machine.

It is strictly forbidden to work beyond the minimum closing height, that is, the minimum distance between the bottom surface of the upper sliding box and the working surfaces is 290 mm. The height after the upper and lower molds is required plus the thickness of the upper and lower backing plates plus the thickness of the tile. It is not allowed to exceed 290 mm. It should be designed according to this requirement to avoid roll forming machine tool accidents.

Always pay attention to observe the height of the lubricating oil in the sliding box and both sides of the roll forming machine. The roll forming machine equipment  should be wiped frequently, kept clean, and no muddy water should accumulate.